Citrus Growing

Citriculture Technical Leaflet

Higher Productivity

Field tests with Mirac®, in Citriculture, demonstrated the full potential of the product. There was an emphasis on the increase in plant vigor; root enlargement; increase in Chlorophyll (SPAD index); increased flowering, fruit set and budding; maintenance of healthy branches in diseased plants; increase in the number and size of leaves and greater tolerance to “water stress”.

Application

Dilute in water;
Spray evenly on the leaves;
Must be used within 4 hours after dilution. If you do not fully use the mixture within this period, shake it again, promoting the homogenization of the Syrup for the reuse of the solution;
It should not be sprayed at the same time with herbicides. If Herbicide has been applied, wait 48 hours to apply Mirac®;
It is possible to use it with other agrochemical products, as long as Mirac® is diluted with the syrup first;
If you used agrochemical products before, use the Mirac®  after 24h;
Avoid use in periods of wind, excessive dew and rain;
Shake the package and syrup well before use.

Security instructions:

Keep the package closed and out of the reach of children and animals;
In case of direct contact with eyes or skin, wash immediately with plenty of water;
In case of ingestion, seek medical advice;
During application, wear gloves, mask and protect your eyes.

Storage:

The product must be stored in a dry, covered, ventilated place at room temperature.

Transport:

Make sure that the place where it will be transported is clean and dry;
Always handle with safety equipment.

Usage limitations:

Exclusive use as Fertilizer.

Phenological Phases for Application

Mechanical/Aerial Spraying: The first application should be made in the Establishment phase, in the Root and Leaf Development stage. The second application should be made in the Culture Development phase, Stem Development stage (when the plant reaches 1.20m ~1.40m).

Manual Spraying: The first application should be done in the Establishment phase, in the stage of Root and Leaf Development . The second application should be made in the Culture Development phase, Stem Development stage (when the plant reaches 1.20m ~1.40m).

Attention: The product must be shaken before and after mixing. After homogenization, use within 4 hours.